Building a Cinewhoop in 2020

I’ve just released the following video showing a full build of a Cinewhoop drone in 2020.

Miscellaneous notes from the video

How to get better at Soldering:

Soldering Practice Device:

Smoke Stopper:

CLI Commands you need: 
set sbus_baud_fast = ON

Full Parts List

Parts on this Drone:
Shendrones Squirt HD: (choose “full kit with damped mount” and “DJI FPV”
FC/ESC Stack:
(alternative stack if that one’s out of stock:
(alternative motor:
Video Transmitter:
Camera :
(alternate Lipo: )
Extra Thumb Screw Standoffs:
Thumb Screw Locks for the top of flight controller:

DJI Products with this Drone:
Get Started with DJI: —
DJI but I want my own radio: —
DJI Receiver Directional Antennas: TrueRC Patch for DJI — (requires 2, not necessary, but amazing)
DJI Receiver Omni Antennas: TrueRC Stubby Singularity — (purchase 1, comes with 4)

Other Peripherals:
Goggles: Fatshark HDO —
DJI Goggles: DJI Goggles and 2 Air Units —
Goggle Receiver Module: IMRC Rapidfire —
Goggle DVR Accessory: IMRC Powerplay —
Goggle Battery Replacement: 18500 Batteries — (go in powerplay)
Radio: Taranis 9XD —
TBS Crossfire : TBS Crossfire —
Patch Antenna : TrueRC MX2 Patch Antenna —
Omni Antenna: TrueRC Matchstick Long –
FPV Bag: Think Tank FPV Airport —
Solder: —
Soldering Iron: TS100 —
Lipo Charger: HOTA 15A —

Screenshots of PIDs: 

4 thoughts on “Building a Cinewhoop in 2020

  • March 26, 2020 at 10:02 pm

    Thanks man 🙂

    Been having very hot motors (brotherhobby 3100kc 1507 6S) tried out the same PID. Filtering settings would help ?

  • March 28, 2020 at 1:10 pm

    What dose having the 200 in feedfoward due in your pids tuning. I used the pids for a similar quad but i am still getting low throttle jello. Trying to figure out the root cause. Thanks and great video/content

    Huginn FPV
    Erik Narramore


Leave a Reply

Your email address will not be published. Required fields are marked *